Disable default configuration in routersetup config file, use defaults in main scripts

[grml-network.git] / man / grml-bridge.8

diff --git a/man/grml-bridge.8 b/man/grml-bridge.8
index 07106ea..76ecb40 100644 (file)
--- a/man/grml-bridge.8
+++ b/man/grml-bridge.8
@@ -12,22 +12,23 @@ command.
 Configure setup via configuration file /etc/grml/routersetup.
 To specify which DEVICES should be bridged, use BRIDGE_DEVICES, e.g.
 
-  BRIDGE_DEVICES="eth0 eth1"
+  BRIDGE_DEVICES="eth0 eth2"
 
-would bridge device eth0 and eth1. 
+would bridge device eth0 and eth2.
+If unconfigured then 'eth0 eth1' is assumed as default.
 Note: The auto interface name is not allowed here!
 
 To specify the name of the bridge, use BRIDGE_NAME, e.g.
 
   BRIDGE_NAME="br0"
 
-Note: this entry is optional, per default the name br0 is choosen.
+Note: this entry is optional, per default the name br0 is chosen.
 
 If you want do disable Spanning Tree Protocol (STP) on your bridge, just set BRIDGE_STP to no, e.g.
 
   BRIDGE_STP="no"
 
-Per default stp is on.
+Per default STP is set to 'on'.
 
 Example Configuration file:
 
@@ -57,7 +58,7 @@ your bridged devices to 0.0.0.0. You can do this with following command:
   `----
 
 Now your bridge is working. If you want that your bridge is reachable, please
-give your bridge an ip adress. You can do this for example with
+give your bridge an IP address. You can do this for example with
 
   ,----
   | ifconfig grml-bridge 192.168.0.1